FINIWATER® TOP A+B

Two-component product based on cross-linked polyurethane dispersion with a hydrophilic aliphatic polyisocyanate. The film obtained after the coalescence and crosslinking phase has the following characteristics:

• high anchoring properties on various supports
• excellent mechanical properties
• good abrasion resistance
• good resistance to solvents
• excellent resistance to atmospheric agents
• good resistance against ethyl alcohol
• glossy appearance

Finishing of resin coatings. Protective transparent for decorative coatings and paints. Painting of concrete floors.

The substrate must have a minimum compressive strength of 25 N/mm² and a tensile strength of 1,5 N/mm²

Each support must be cleaned, degreased and free of old paint during detachment.
Abrasive superficially to promote adhesion. It is recommended to use abrasive papers with a grain greater than 150, clear if possible. After abrasion completely remove dust from the surface.
As top-coating of resin coatings, it is necessary to proceed with the application by verifying the coating time of the previously applied product.
Surfaces tending to chalk will be treated in advance with a recovery of PAVIWATER T68 or PAVIWATER TES, both diluted 1:3 with water.

At the time of application, combine the two components in a single container and mix carefully using a mechanical stirrer. Apply by roller the mixture with a consumption of 0.100-0.125 kg/m² (for a film of about 40 microns). For the application it is recommended to use suitable medium-pile rollers.
To obtain a rough and non-slip surface, 3% of SFERETTE DI VETRO FINI must be added when preparing the 2 components (see table). Avoid films that are too thick, as this would delay the development of the final characteristics of the film, especially deep drying and sensitivity to water.
If necessary it is possible to dilute the mixture with water up to a maximum of 10%.

Attention: due to the drying speed of this type of product, particular attention should be paid to the time of application, in order to avoid imperfections such as rollers, overlaps and gloss differences. In general, proceed to distribute the paint on the support homogeneously in the right quantity. When joining the newly painted area, take care to resume the painting a few centimeters away in order to discharge the excess product and then connect with the previous area by blending and dosing the quantity applied carefully. Do not wait too long for overlaps, always paint "fresh on fresh".
Be careful not to leave unpainted areas, in doubt we recommend the application of two coats of product.
In the realization of large surfaces, the coordinated movement of several applicators is required.

Product for professional use, the buyer undertakes to follow the above warnings in the application of the purchased product and the instructions in the safety data sheet.